ZEKTORMAS3Multi-channel Audio SwitchOwner’s Manualwww.zektor.comRev: 2 03/12/04TM
10STEP 11 11 After a pause, the Power indicator blinks 7 times, and repeats.Press the key on your remote that you want to use as the new key for POWER
11Bright / Dim / Auto-dimming ModesSetting the Display intensity modes of the MAS3The front panel display of the MAS3 can be set to Bright, Dim or an
12Setting Power On DefaultsThe MAS3 power on default modeWhen toggling between Standby mode and PowerOn the MAS3 will remember all it’s current set-ti
13Restoring the MAS3 to Factory DefaultsRestoring the MAS3 to the factory defaultsThere are many ways to program the MAS3’s remote capabilities. Most
14Typical ApplicationLSUBLRCENTER RDCinputOUT321LSUBLRCENTER RLSUBLRCENTERRLSUBLRCENTERRSACD playerDVD-A PlayerSACD Player # 2To 6 channelPre-AmpMAS-3
15Warranty InformationWarranty PolicyZEKTOR, LLC warrants this product against defects in material and workmanship under normal use and service for on
16Customer Service Contact Information:ZEKTOR, LLC12675 Danielson CourtSuite 401Poway, CA 92064Email: [email protected]
2Important Safety Instructions!Read all instructions for prior to installation of your product.Retain this User's Manual for future reference.Adh
3A MAS3 OverviewOperating the MAS3 is straight forward and simply a matter of plugging the MAS3’s power supply into an available A.C. outlet, and then
41234567890PIP ENTTV VCRCBL /SATDVD RCVRPOWERVOLCH++__Using the MAS3 with a Remote ControlRemote operations of the MAS3 are accomplished through the u
5Programming your Remote ControlSetting up your Universal Remote ControlFor remote control operations, the MAS3 requires either a Universal Remote con
6Using Different Remote CodesUsing Alternate Component Keys on your RemoteThe MAS3 will also respond to alternate component key codes. Allowing you to
7STEP 1 1 Place the MAS3 in standby mode. This is the factory default mode on power up, and if it has not been changed, you can unplug the MAS3 and pl
8Learning New Remote CodesTeaching the MAS3 to use new remote control keysIf your remote does not have one of the pre-programmed component codes, or y
9STEP 4 4 The Power indicator blinks slowly, and input 2 is selected.Press the key on your remote that you want to use as the new key for SELECTIN2.1
Comments to this Manuals